TRACING: Line marking paint

THE EASY-TO-USE LINE MARKING PAINT TRACING® line marking paint is used to mark out surfaces and optimize traffic flows both TRACING® line marking paint is used to mark-out surfaces and optimize traffic flows both indoors and out: logistics warehouses, sports centres, grass sports fields, cycle paths, or car parks. TRACING® is ideal for marking out floors and other ground surfaces in low-traffic areas. This is the best quality/price compromise for outside line marking.

PRO MARKER characteristics

• Excellent adhesion
• Temperature range: 5°C to 50°C

Easy application with marking accessories

Composition of PRO MARKER

• Binder: acrylic
• Pigments: mineral and organic, lead and cadmium-free
• Solvents: a complex blend free from chlorinated solvents and aromatic compounds (toluene,xylene, etc)
• Propellant: a specific mix of isobutane and propane

Properties of the TRACING line marking spray paint

• Excellent adhesion.
• Good weather resistance and fast drying: 15 to 20 minutes or less.
• Crisp, sharp lines thanks to its purpose-designed nozzle.
• Application temperature: from +5°C to 50°C.
• Aerosol cans, volume 600 ml / 500 ml net, in boxes of 12.
• Aerosol cans, volume 1000 ml / 750 ml net, in boxes of 6.

To apply:

• Manually or using our application equipment (line marking trolleys, spray gun handle, or One-wheel marking paint applicator)
• Drying Time: 15 to 20 min.
• Use head down, adjust the position of the aerosolin the equipment used to give an application height that produces the desired line width.
  
  BEFORE USE:
  Shake the can vigorously in an upside-down position to thoroughly mix the paint, and continue shaking even after having heard the ball bearings.
  
  AFTER USE:
  Purge head up (until gas only comes out) to clean the valve and nozzle.
  
  GENERAL CONDITIONS FOR USE
  Whatever the nature of the surface, the following conditions are essential for the optimal application of TRACING®.
  
  Correct preparation of the surface to be painted is imperative to obtain excellent paint adhesion. Thoroughly clean the surface to ensure that it is free from dust, dirt, grease, etc.
  
  Relative humidity should be between 10% and 50%.
  
  The application temperature should not be below 5°C.
  
  For a good quality line, the first coat should be applied quickly (print layer); on the other hand, the second and optional third coats should be applied more slowly to obtain the desired coverage.
  
  RECOMMENDATIONS BY SURFACE TYPE
  CONCRETE:
  Before applying TRACING® to a new concrete surface, allow a minimum of 3 to 4 weeks for complete drying (French building trades standards) and the elimination of acidity.
  
  ASPHALT:
  It is advisable to wait at least 15 days before line marking a new asphalt surface in order to avoid any alteration to the quality of the marking.
  
  Special conditions applicable to “synthetic” (plastic, PVC, varnishes) and painted (epoxy, PU) floor surfaces. In this domain, there are several different types of paint and the paint used for the floor may be incompatible with TRACING® (resulting in poor adhesion). We therefore recommend carrying out a test beforehand for these specific types of surfaces.

Health and Safety

• No paint mist or drips during use.
• high pressure
• spray flammable
• Product is safe for the user, the environment, not toxic